Check your owners manual it will tell how to shut it off or if it doesnt tell you then a dealer service dept. has to do it
To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
That requires a scan tool.
hold the buton on the cluster then turn the key to ignition
What warning light? The only warning lights that can be reset are the Maintenance Required and Check Engine Light. The Maintenance Required light is reset in different ways depending on model and year. The procedure is listed in your owner's manual. Reset the light after performing scheduled maintenance listed in your owner's manual, usually oil/filter change. The Check Engine light is reset by repairing the problem then unhooking the battery for 15 minutes, on a pre-1996 vehicle. On a 1996 and later vehicle it normally requires you use an OBD2 scan tool to reset the light. If you do not repair the problem that set the fault code, the light will just come back on. Your oil pressure warning light means you have low oil pressure, temp warning light means the engine is over heating, alternator light means the charging system has a problem.
maintenance with engine
aperantly take the light out
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
The maintenance required light requires a scan tool to be reset.
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
How do you reset the maintenance light on a 2001 Honda accord ex I found some options at http://www.tegger.com/hondafaq/maintenance-reqd-light.html#why
With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.