RESETTING OIL SERVICE INDICATOR:
If your OBC needs to be reset after completing your oil change, there are two ways. NOTE: If you miss a step, just turn the key back off and try again:
A. Model Year 1999 to Mid-2000: You should have the older round 20-pin DLC connector under your hood behind the battery terminal, you need to use a small length of wire to connect (short) pins 7 and 19 for 3-5 seconds with the ignition key in position 1 (Accessory).
B. After Mid-2000: You should not have the 20-pin DLC connector. You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it again for another 5 or so seconds until RESET or RE flash. While the display flashes, press the button one more time briefly. If done correctly, END SIA should show up for a few seconds. All done.
How to reset service light on a 2004 grand am
How do i reset my service light on my 2004 Nissan
The service light indicator on a 2004 Chevy Cavalier tells its owners when to send the vehicle in for maintenance. To reset the light, unplug the battery for five seconds.
please help me!!!! How do you reset service light for a 2004 holden commodore Calais?
with a dignostic tool
To reset the service engine soon light on a 2004 GMC Envoy you can remove the ECU fuse. ECU stands for electronic control unit.
Removing battery ground cable for a couple minutes should reset the light
I reset the FSS by refering to the Owner's Manual.
You can reset your 2004 Lincoln Town Car service engine light by scrolling to the oil life display. Hold the scroll button in until the oil life goes to 100 percent.
how do you reset change the oil light in a 2004 alero?
I am sure this is not the proper way to reset the light, but I disconnected my battery cable for ten minutes and it fixed the problem.
I am not sure about the 2007 model. 2004-200 Models: The answer is in the manual. If you do not have the manual: After you turn on the engine, hold the trip reset button until the service remainder resets.