Wot make of radio u got? Reset? Is it working at all or does it need a new security code?
On the rover 416 the fuel cut off switch is behind the centre console drivers side, roughly behind the radio.
The radio fuse on a Rover 400 Series is typically located in the fuse box, which can usually be found in the driver's side footwell area or under the dashboard. To access it, you may need to remove a cover or panel. Refer to the vehicle's owner's manual for the exact fuse layout and identification to locate the specific fuse for the radio.
To reset the radio in a 2003 Range Rover, first, ensure the vehicle is turned on but the engine is not running. Then, locate the radio unit and press and hold the "Power" button along with the "Menu" button for about 10 seconds until the system resets. If this doesn't work, you may also disconnect the vehicle's battery for a few minutes to reset the entire electrical system, including the radio. Always consult your owner's manual for specific instructions related to your model.
to reset you have to press the button that says doodlebops
To reset the touch screen radio in a 2006 Range Rover, start by turning on the vehicle and then disconnect the vehicle's battery for about 10-15 minutes. Reconnect the battery, which should reset the system. If that does not work, you can also try pressing and holding the "Menu" and "Power" buttons simultaneously for about 10 seconds. If issues persist, consult the owner’s manual or a professional for further assistance.
hoe do you reset the check engine light in a 1995 land rover
iT WILL RESET WHEN THE PROBLEM IS REPAIRED.
To remove the display from a Rover 400 clock radio, first, unplug the device to ensure safety. Carefully use a flathead screwdriver or a similar tool to pry off the front panel without damaging it. Once the panel is loose, gently disconnect any wiring attached to the display. Be cautious during this process to avoid breaking any components.
There is nothing to reset except the radio. Insert the 5 digit radio code to reset the radio and then reset the clock and presets for stations.
you have to open the glove box part and there will be an remote take that remote central and take to a scrap yard and ask them for another one and change it.
you have to take to a rover dealer to put out the service light
You can find a diagram regarding the installation of a replacement ball, on your Range Rover 400, at most Range Rover dealerships. Most auto-parts stores will have the diagram.