1. With the car in park, turn the key to the on position. Turn off your stereo, fan, etc. All your dash lights should be on. The warning lights will all turn off, except the security light left blinking.
2. Leave the car in the on position for 10-15 minutes. Come back and the light should now be off.
3. Turn the key to the off position for 10 seconds, then start your car no problem:)
If this doesn't work, you may need to repeat the above steps two (2) more times to reset the module. If this doesn't work, you need a new PassLock module (around $400 from what I've read).
I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner
It probably won't start
always on nomatter what i do
The security light on a 2001 Chevy Astro Van can be reset by disconnecting the battery for 30 seconds. This resets the system and turns out the light until another problem is detected.
Gm does not use inertia/reset switches.
how i can reset the security sistem for a Pontiac 2001 grand am
Open up the drivers side door and you will see a cover pannel on the dash side. Pull the open and press the reset light until the light flashes. You must have the car ON.
On the driver side when you open up the door look at the end of the dash...there is fuse door open it and hold down the red reset button till the light come off.
Gm vehicles do not use inertia/reset switches.
GM vehicles do not use inertia/reset buttons
After changing the engine oil, you must reset the system. To reset the system, you must do the following: 1. With the ignition key to ON, push the RESET button located in the driver's side instrument panel fuse block. 2. When the CHANGE OIL light starts to flash, press and hold the RESET button again. The reset is complete when you hear the chimes sound and the CHANGE OIL light goes out. I can e-mail you the manual for the Alero 2001 for 14.95 us forward your payment to paypal send to : ray_rayon@hotmail.com use paypal If you want the Alero use manual on CD then 29.95us
On my 2000 Alero I open drivers door and open fuse panel door. Then turn key onposition but don't turn engine over. Push in reset button until the light you want flashes then hold the reset button for a few seconds.