On my 2000 Alero I open drivers door and open fuse panel door. Then turn key onposition but don't turn engine over. Push in reset button until the light you want flashes then hold the reset button for a few seconds.
Have vehicle scanned to determine the problem and have codes cleared
Service lights can be reset by following a few simple instructions located in the owners manual. Resets of this kind may be different for each motor vehicle.
Have vehicle scanned to determine the problem
To reset the "Service Vehicle Soon" and "Trac Off" lights on a 2003 Buick Century, first ensure that any underlying issues causing the lights to illuminate have been addressed. Disconnect the negative battery terminal for about 10-15 minutes to reset the vehicle's computer. Reconnect the terminal, and start the vehicle to check if the lights have turned off. If they remain illuminated, consider using an OBD-II scanner to diagnose any persistent trouble codes.
turn off engine, and start again
have vehicle scanned to determine the problem
how do you reset change the oil light in a 2004 alero?
How to reset oil light on bm,w 750li
You'll need to use a scan tool or other OBDII software to reset your service lights.
It will vary for your particular vehicle.
In most cars, a service vehicle light can be reset by disconnecting the battery cables for one minute. After the cables are reconnected , the light should turn off.
wait 10 minutes for the passlock system to reset for a GM vehicle.