wait 10 minutes for the passlock system to reset for a GM vehicle.
Press mode button three times The seconds will flash, press start/stop button to reset it Press lap/reset button The minutes will flash, press start/stop button to advance it Press lap/reset button The hour will flash, press start/stop button to advance it Press lap/reset button The date will flash, press start/stop button to advance it Press lap/reset button The month will flash, press start/stop button to advance it Press lap/reset button The day of the week will flash, press start/stop button to advance it
To reset outdoor sensor lights, first turn off the power to the lights at the circuit breaker. Wait for a few minutes, then turn the power back on. This should reset the lights and they should start working again. If the issue persists, consult the manufacturer's instructions or contact a professional for assistance.
They're the flash bulbs from cameras.
check if your lights are still on that drained the battery
With the key in the off position, hold down the trip odometer reset button until the dash lights start flashing. When it is all done start the car, and see if it reset.
it is due a service and the garage can reset the light
It is normal for it to do that when you reset it. NO worries
Blue lights flash in your eyes and they start sizzling and get hot. Nothing else.
To reset the electric immobilizer you must put the key into the ignition and slowly turn it. You should see the lights in the car start to turn on.
This will only work if you have a trip odometer: 1. Put the key in the ignition, but leave the switch turned off. 2. Push your trip odometer reset button in and hold it in. (Important: do not release the trip reset button or you will have to begin the process over.) 3. Turn key to last position before engine tries to start, but do not start engine. (your dummy lights and dash lights will come on) 4. Continue holding reset button pushed in. 5. You will see five dashes (-) in place of the numbers for your odometer read out. They will flash and then there will only be four. Each time they flash off and back on, there will be one less until they all disappear and then you will see zeroes all the way across. 6. Once you see the zeroes all the way across, you know it is reset. You may now release the trip reset button. 7. If you accidently release the trip reset button before the process is complete, just start over and make sure to hold the button in until the process is complete.
Turn the key to on, do not start, push the gas pedal to the floor three times, the light should flash on the dash indicating the reset. Turn the key off. You should be reset.
Reset computer,