A combination of pulling and pushing the 2 speedo buttons at the same time. This should reset the service light.
jaguar s type twin turbo diesel 2007. how to cancel "service required" indicator.
how do you reset the digital miter timing belt light on Isuzu 2.8 turbo diesel
you need to have to computer in your car reset. it will automatically turn oil light on after a certain amount of miles.
I don't know if this will work for non-turbo models or other years of the S80, but it worked on my 2001: 1. Insert ignition key and turn to position I. 2. Push in the odometer reset stalk and hold it in. 3. Turn the ignition key to position II. Continue to hold the odometer reset stalk in. After a few seconds the Service light will begin to flash. 4. Release the odometer reset button. 5. Turn the ignition off. You're done!
Disconnect the battery for two minutes, then re-connect it.
I don't know if this will work for non-turbo models or other years of the S80, but it worked on my car: 1. Insert ignition key and turn to position I. 2. Push in the odometer reset stalk and hold it in. 3. Turn the ignition key to position II. Continue to hold the odometer reset stalk in. After a few seconds the Service light will begin to flash. 4. Release the odometer reset button. 5. Turn the ignition off. You're done!
Pull the dashboard apart. Others you can simply reset the ignition module by a sequence, but this one you have to reset it manually on the inside.
the only way to reset that light that i know of is to take it to a dealership
How do you turn off the electronic engine management systems light indicator on the dash
The car diagnostic warning light is a warning indicator. This means that something is wrong with the vehicle and needs immediate attention.
The service on light is pre programmed to switch on at pre-determined intervals to rmind you to take it in for maintenance.
After repairing the cause, the code is reset with a scan tool.