unplug the control module fuse and disconnect the battery for 5 minutes.
Contact the dealer.
i have same problem with 84 eldorado oftem, i disconect positive wire from the battery and wait a few minutes it should reset itself.
Grab a light and start looking. Might have to start the vehicle so the system pressurizes, but it's a visual inspection.
the engine
On a 2002 Pontiac Grand Am: turn the key to the on position for 30 minutes or until the security light goes out. The car should start.
The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL message being turned on, reset the system. Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the CHANGE OIL message, do the following: 1. Press reset stem till it Displays "OIL LIFE" on the DIC.(3 times) 2. Press and hold the reset stem. The oil life will change to 100% and a beep will sound. 3. Turn the key to LOCK. If the CHANGE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure. Hope This Helps.
I am sorry to report that it does Not have a reset button.
its called a vats system and you have to get a new key mad at the dealer if that's the problem
turn the key to on position, dont start it, then press the gas pedel three times with in seconds,turn the car to off position. then start the car it should go of in seconds, it may take a couple of time to get it right. hope this helps ENGINE OIL LIFE SYSTEMHOW TO RESET THE ENGINE OIL LIFE SYSTEMThe Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.After changing the engine oil, the system must be reset as follows:# Turn the ignition to "RUN", with the engine off. # Press the "information" and "reset" buttons on the DIC at the same time to enter the personalization menu. # Press the "information" button to scroll through the available personalization menu modes until the DIC display shows "OIL-LIFE RESET". # Press and hold the "reset" button until the DIC display shows "ACKNOWLEDGED". This will tell you the system has been reset. # Turn the key to "LOCK". If the CHANGE OIL SOON message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the reset procedure. this it the actical reset procedure from alldata pro
Most of the time if you lock the vehicle from the outside using the key fobb and then unlock the drivers door with the key, it will reset. Otherwise you can start the car, shut it off, open the drivers door and try it again. If neither of those works you are going to need to find the fuse for the system and pull it out so you can drive it to the dealer.
Your vehicle has a carburetor so there isn't a reset button for the fuel pump
Resetting the maintenance light on a 1999 Nissan Altima requires access to the engine compartment of the vehicle. Once their locate the battery and disconnect the negative cable for 5 seconds. Doing so will allow the system to reset.