answersLogoWhite

0


Best Answer

new tyre pressure sensor reset megane

Sometimes resets if you blow up the tyre about 5 lbs above then adjust to correct pressure.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the tire pressure sensor fault on Renault megane 2004 please?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Coolant sensor in a Renault megane?

Yes there is a coolant sensor in the Renault megane.


Where is the temp sensor?

Renault Megane Dymanique


Where is the tdc sensor on a Renault megane 1.6 rxe?

at the back


Location of Coolant temperature sensor in Renault scenic megane?

The coolant temperature sensor in a Renault Megane Scenic is located on the right hand side of the engine as you are looking at it. It is located just above the TDC sensor.


How can i reset the steering angle sensor on my Renault megane?

It has to be reset by a Renault dealer (or anyone with a Renault Clip diagnostic).


Where is the air flow sensor in the Renault megane?

Next to the air filter box


Where is output speed sensor on a 2005 Renault megarn senic?

On a Renault Megane Scenic, the output speed sensor is usually situated behind the gearbox. It can only be felt because it is small and has wires connected to it.


Where is the external temperature sensor in a Renault Megane Fidji Scenic 1.6 2003?

The sensor is in the near side wing mirror If you look at the bottom of the mirror you can see it


Where is the Coolant sensor located on a Renault Megane?

on the thermostat housing at the top of the engine block, normally secured by a spring "c" clip.


Orange light in Renault Laguna dashboard?

its the tyre pressure sensor


Why does Renault megane infra red sensor stop working?

may be a loose connection. You can take out the housing by sliding the plastic forward over the IR sensor. You can then check that connections are clean


Renault Megane Scenic wont start when hot?

crank shaft sensor take off and clean it is on the bell housing ofthe gear box