police in Tampa
how can you reset the headrests after deployment
It is every 13K miles.
I believe it is in the front passenger footwell , by the kick panel
my 1996 Ford E-350 cutway has the reset switch located behind the kick panel ahead of the passenger side door.
E-350
The RSC sensor is located on the steering collum, Under the dash by the Optic Wheel.
The E 350 coupe is a superb car from the Mercedes Benz based on the E class platform, but smaller !
i have a 1998 e-350 with the powerstroke 7.3l in it. i have it loaded all the time and get 18 mpg
on the 1992 e-150 the tank is 35 gallons and on the e-350 it is 45 gallons
The RSC (Roll Stability Control) sensor on a 2008 Ford E-350 van is typically located near the vehicle's center, often mounted on the frame or body near the rear axle. It may also be found in the vicinity of the vehicle's traction control module, which is usually located under the driver's seat or within the engine compartment. For precise location, it's best to consult the vehicle's service manual or a repair guide specific to the E-350 model.
To reset the engine check light on a Ford E-350 van, you can disconnect the negative battery terminal for about 10-15 minutes, which will clear the diagnostic trouble codes. Alternatively, you can use an OBD-II scanner to read and clear the codes directly from the vehicle's computer. However, if the underlying issue isn't resolved, the light may reappear. Always address the root cause of the warning light before resetting it.
Click on the link below Click on Owner Guides The owners manual ( which includes the fuse diagram ) can be viewed on-line