Some don't have wires, the coils are mounted direct to the spark plugs. Some have a dual spark plug design where the plug mounted coil also sparks another spark plug on the other side of the engine. Removint these spark plug wires will still allow the engine to run but will eventually ruin the coils. And the third type will not run with out wires.
A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.
you would follow the spark plaug wires from the disributor to the spark plug and replace it. Spark plug wires are different sizes in length depending on where they go. Also make sure they are in the right order or your engine might run rough.
There are electrical wires all around the vehicle. If you are looking for spark plug wires, it does not have any. It has individual coils directly on each spark plug.There are electrical wires all around the vehicle. If you are looking for spark plug wires, it does not have any. It has individual coils directly on each spark plug.
perhaps you connected your spark plug wires incorrectly check your firing order if you crossed a couple of spark wires the engine may still run but very roughly also you may have spark plug wires that are not fully connected to the plug are you reusing the old plug wires may be time for a new set check connectors for corrosion recomend using high quality spark plug wires
The spark plug wires on your 1994 Chevrolet Caprice are quite easy to change. The spark plug wires simply lift off on each end. Put the new spark plug wires on and push until you feel a click.
change only one wires at a time,matching each to length.
There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.
at the end of the spark plug wires
OEM are the best spark plug wires for the Honda cbr. These spark plug wires can be found at the local Honda dealership.
Yes, if the spark plug wires can be connected to the distributor and works.
DEPENDS ON THE YEAR AND MOTOR,DO YOU HAVE SPARK PLUG WIRES?IF NOT,THEN YOU HAVE A SEPERATE COIL FOR EACH SPARK PLUG THAT SITS ON THE TOPS OF THE PLUGS,IF YOU DO HAVE SPARK PLUG WIRES THEN JUST FOLLOW IT FROM THE SPARK PLUG TO THE COIL!HOPE THAT HELPS
Disconnect the battery, and remove the spark plug wires one by one. Replace the spark plug wires in the same order, ensure the connection is firm, and connect the battery.
Spark Plug wires connected incorrectly, or engine is out of time.Spark Plug wires connected incorrectly, or engine is out of time.
Disconnect the battery, remove the spark plugs wires and boots and remove the spark plugs. Put in the spark plugs, replace the spark plug wires and boots, and connect the battery.
Changing the spark plug wires in your 1999 Mercedes-Benz is quite simple. The spark plug wires simply lift off. The new spark plug wires can be pushed onto the spark plug. It is best to change one wire at a time.
Pull the spark plug wires off the spark plugs. Remove the spark plugs with a spark plug socket. Install the new spark plugs and put the spark plug wires back on. I recomend replacing the spark plug wires as well. If replacing them, just remember that the new wires are hooked up the same ways that the old ones came off.
all the spark plug wires go to the distributor.
A Distributor cap is the device that the spark plug wires are connected to. It distributes spark from the ignition coil through the wires to each spark plug.
Are you referring to spark plug wires
To replace spark plug wires on a 3300 Oldsmobile engine, open the hood and remove the wires from the end of the engine. The number of spark plug wires most often corresponds to the number of cylinders your engine has.
Not very well, if at all.
The 1988 Chevy Cavalier spark plug wires are quite easy to remove. The spark plug wires simply pull off on each end. Put the new spark light wires on by pushing downward on each end.
there are no wires. each spark plug has it's own "coil on top" remove the coil by pulling straight up . then remove and replace the spark plug. That wrong ther are wires on the 3.5 and it,s not easy you need to remove the intake manafold to remove & run new wires
If you mean, what if your spark plug wires were crossed up, the engine would run terrible if it ran at all.