Don't make the mistake of stacking it up there. That is a dangerous proposal. Use the sheeting as you hand it up.
a sliding roof
the sea erodes the stack to such a point until the wasn't enough suport and the roof colapsed making the arch become a stack.
I just looked at the sliding roof diagram in the RX300 (2000) repair manual. The motor is located at the front center of the roof opening. It looks like it's just in front of the sliding roof controls.
What is the developed lenght and a VENT STACK should be no less then 4" passing through the roof full size to prevent hoarfrost
You go Ninja. Also static and sliding friction help you
A smoke stack. IHOP that was helpful.
A stack vent is is the extension of a soil or waste stack above the highest horizontal drain connected to the plumbing stack Vent stack a vertical vent pipe extending through more then two stories which is then connected to a stck vent or is otherwise extended throgh the roof, installed primarily for the purpose of providing circulation of air to and away from any part of the drainage system
Sure, if you have enough money.
A shiver bar is a small, narrow strip of wood that is used to attach the ends of roof thatching to the roof's surface. It helps to secure the thatch in place and provides a neat finish to the roof.
Nope, should be 4" to prevent hoarfrost
Depends on where you live, in Oklahoma -- 12 in. above roof. you just want it high enough so snow does not cover the top of it
To repair a hole in your leaking roof, you will need a bundle of shingles, a trowel or crow bar, nails, a hammer, and a flat head screwdriver. You will also want to be wearing a pair of nonslip pair of shoes to prevent you from sliding on the roof.