You don't, it sets itself from radio signals transmitted by NIST. Depending on reception conditions it may take a few days (sometimes in really bad cases a few weeks) to get good enough signal to set itself with.
You don't ... you throw it away.
You don't, it sets itself from radio signals transmitted by NIST. Depending on reception conditions it may take a few days (sometimes in really bad cases a few weeks) to get good enough signal to set itself with.
FALSE
The radiometric clock is set when the rock is formed. Because this is when it sets, radiometric dating is used by geologist to find out when the rock was formed.
Push the Time button once. This will change the Month/Day window to Alarm 1. Push the up button until the desired time zone is reached. Push the Time button twice more to return back to Month/Day display.
how do you change the day of the week? model spc1003
How do you set the time on a S10/Scan atomic clock model 86715
Press the down button on the back of the clock to go between 12 hour & 24 hour.
An atomic clock should set itself once it receives the calibration signal .
I have a 433MHz transmiitter il sale you if you wont it my email is gregory_longworth@yahoo.com
how to shut off alarm on clock
Make sure the channels areset to the same number. Push the reset button in the battery chamber of the outdoor unit with a paper clip. Then hold the SYNC button on back of the main unit until it beeps.
Try this (it works for a similar model): For the Sharp SPC374T Atomic Clock - Time Zone setting- Press the "Time" button once, the time zone will show where 'Day' usually is (e.g., "PA" for Pacific), use the Up or Down button to adjust. Press the time button once to save.
Try this (it works for a similar model): For the Sharp SPC374T Atomic Clock - Time Zone setting- Press the "Time" button once, the time zone will show where 'Day' usually is (e.g., "PA" for Pacific), use the Up or Down button to adjust. Press the time button once to save.
Any atomic clock will automatically set the time.
1. Press Clock 2. Press Clear 3. Enter the time in 12 hour format 4. Press Clock again