0
What else can I help you with?
How do you set the clock in a '92 Chevy S10 Blazer?
push the set button then within 10 seconds push the seek and scan buttons to change the time.
How do you set the clock on 1986 Chevrolet S10 pickup?
Turn radio off. Turn ignition switch on. (engine not running). Pull OUT seek button to change hours. Pull out scan button to change minutes.
How do you set the clock on a 1995 S10 pickup with Delco cassette Radio?
I have a 97, hope it is the same. You hit the set button, and the hour will flash, you use either the scan, or seek button to change it. one does the hour, the other the minute. When you have the correct time, hit set again, and there you go.
How do you set the clock on a Chevy S-10?
97 Chevy s10 pickup. Turn the power off on the radio. Press the [set] button, like you would to do your presets. The word set will show on the display. Press the [seek] button to change the hours and the [scan] button to change the minutes. Then press [set] again to save the time.
How do you set the clock on a 1998 Chevy S10 truck?
Make sure you have the radio turned off when you push the SET button.Push the SET button once. While it stays lit on the display, push the SCAN button to adjust the hour, push the SEEK button to adjust the minutes. Push the SET button once again to "set" the time.
What do you have to do when you put a new clock spring in a 2004 Chevy S10 How do you set the clock spring?
start by removing the airbag assembly which will be attached by four screws on the back side of the steering wheel. Usually these are small torx bit screws. Once that is done you can carefully remove the airbag and then undo the wiring from the airbag (with the ignition OFF) After that remove the steering wheel insert and the clock spring is on the back side. Carefully remove it as to not damage the plastic retainer. Reverse these steps for install.
How is the airbag light reset on a 2002 Chevy S10?
The air bag light is on because the air bag system has detected a problem with the system. Once the repair is made the system will reset the light itself. One common possibility could be a faulty "clock spring". Take the vehicle to a trusted mechanic for diagnoses.
What is wrong when service engine soon light stays on on 96-S10?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
What usually is wrong when service engine soon light stays on on 96-S10?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
How do you set the clock in a 2000 S-10 pickup truck?
ON my 2000 S10 4.3L 6 cylinder. Right lower corner of Radio/Casset. Push "HR" button to change hour and "Min" button to change minutes. Just keep button pressed until time starts changing. In owners manual. John Raymond
How to change Serpentine Belt on a 1989 Chevy s10 blazer?
insert a 1/2" rachet into the tension pully, pull clock wise this will relive the tension on the belt thus allowing you to remove the belt repet to install new belt. make sure the groves of the belt are properly in place before relasing the tension pully back to tension
Reset drivers airbag light on Chevy s10?
use a scan tool and reset the light waalaa But, if the reason the light came on is not fixed the light will only come back on.
