On the bottom right of the display is a hole marked "date/timeset" You can use an ink pin or some such.
First push and the minutes will flas. Second push the hour will flash You can push either the "range" or "temp/time" buttons for scrolling.
Third push the date will flash.
Fourth push the month.
Fifth push the year will flash
The sixth push will exit.
you will see arrows pointing downward above the "temp time" button upward above the "range" button push eiter to increase or decrease the Disply that is flashing. You an change the flashing disly one increment at a time or hold the button in to change it rapidly.
WITH THE RADIO OFF BUT CAR ON.AND THE CLOCK DISPLAYING PUSH THE SET BUTTON JUST BELOW THE CLOCK.THEN USE THE SEEK CONTROL AND THE SEARCH CONTROL TO SET THE TIME ONCE YOU HAVE SET THE CLOCK PUSH THE SET BUTTON AGAIN..REAL SIMPLE.
The idle speed on your 1995 Cadillac Eldorado can be set by adjusting the fuel pump adjustment screw. Turn the screw to the right to increase the idle speed.
hope this may help, on my 88 eldorado. it is reset or changed by pin hole. Look for a small needle hole in the area of display. mine is on lower right corner of center console, right below time and date display message.
Use the set buttons.
.035" is factory using standard point type ignition.
the secret is to have the radio off set button then just play with scan and seek
Look it up on the internet, a majority of manuals are on the internet.
To set the clock on your 1994 Cadillac DeVille, turn the ignition on with your key. On the bottom right corner of the clock you'll find the 'set' button. Press the button and immediately press and hold the 'seek' button. When the clock gets to the hour you want, release the 'seek' button. Next, press the 'set' button again and press the 'scan' button, and hold it while it scrolls through the minutes. When it displays the correct minutes, release the 'scan' button.
Hold set button, Push seek for hours, push scan for minutes.
With the ignition on, press and release the "set" button on the radio. Within 5 seconds, push the "Scan" button to set the hour, push seek to set the minutes.
Turn the ignition to run. On the radio controls, PULL the scan button out to set the hour. Once the the hour is correct, PULL the seek button out to set the minutes.
likely thermostat is stuck. The temp blend door actuator has failed.