0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the oil sending unit located on a 99 Chevy Tracker with a 2.0 engine?
BEHIND THE MANIFOLD..ON THE LEFT SIDE OF ENGINE
Where is the dip stick on a 99 Chevy Tracker?
The dip stick is on top of the valve cover in the middle,should have a yellow top.
Will the seats from a 99 tracker fit in a 96?
The seats from a 99 tracker will not fit in a 96 because they are bigger.
How do you set the clock in a 99 Oldsmobile alero?
How do you set the clock in a 1999 Oldsmobile Alero? I did not receive a book with the car and I really would like to have the right time in my car.
Speaker size for 99 Chevy Tracker?
i am rather sure that the speaker size in the door of the 99 chevy tracker are 6 3/4 inch or 6 1/2 inch there is a bracket that can be removed from the door to take with you when shopping for them , and i also know that a jensen power plus 652 will fit in it hope that helps soon i will take apart my rear and help with the back ones
What should the idle be set for a 1999 Chevy Tahoe?
idle speed for a 99 Tahoe
Where is the front differential actuator on 99 Chevy Tracker located?
the air pump is on the back of the front bumper, the rest in your front axil inbtween you ring gear and your carrier
How do you Disable Speed Governor on 99 Chevy Malibu?
no speed governor, it is set at factory by the computer.
How do you set the timing on a 99 Chevy s10 blazer?
There is no timing to set. The timing is controlled by the ECM with signals it receives from various sensors.
Is a 99 Chevrolet tracker brake caliper bracket interchangeable with a 96 Chevrolet tracker?
no the caliber are different.....
Very rough idle when dropped into gear on your 99 Chevy Tracker with the 2.0 engine runs fine otherwise have replaced the PCV and plugs no help?
you need the fast idle adjusted on the engine you may have idle set where it sounds fine in idle but not high enuff when dropped in gear.
Whats the valve lash clearance for 99 Chevy Tracker 1.6?
.006" intake .007" exhaust Standard screw and locknut adjusters. Set the clearance when the engine is cold. Be sure to set each valve with cylinder at TDC. (top dead center) I suggest replacing the valve cover rubber gasket when adjustig the valves, as they do get old and can crack/leak.
