no the caliber are different.....
To replace the front rotors on a 1994 Geo Tracker 4X4, begin by safely lifting the vehicle and removing the front wheels. Next, remove the caliper by unbolting it from the bracket, and hang it securely to avoid stressing the brake line. Afterward, remove the caliper bracket and then the old rotor, which may require some gentle tapping if it's stuck. Install the new rotor, reattach the caliper bracket and caliper, and finally, reinstall the wheels before lowering the vehicle.
caliper bolts 23fl/lbs. caliper bracket bolts-50ft/lbs providing the truck your are referring to is a half ton. fyi, z71 is nothing but an off road package, not a model of truck. Chevrolet has a z71 package on their tracker, s-series, and just about every other vehicle equipped with four wheel drive. i hope this helps.
Chevrolet Tracker was created in 1988.
On my 2001 it is to the right of steering column just under edge of dash next to center console. On a bracket facing down.
It was offered by Chevrolet from 1989 through 2004.
A Chevrolet Tracker.
No, its made by Suzuki. Its really a Suzuki Escudo badged as a Chevrolet.
Yes it is what General Motors considers the replacement.
You can find a diagram for a 2.0 Chevrolet Tracker engine in the owner's manual. You can also find it at various auto retailers.
Suzuki and Peugeot do not share parts. 4-cylinder Grand Vitaras built before 2006 have some interchangeable parts with Chevrolet Tracker vehicles, because Suzuki was building them for General Motors.
under the dash
The 2001 Chevrolet Tracker starter relay is mounted on the top of the starter. The relay switch is attached to the starter with two retaining screws.