timing/XR80_Align the line on the rotor with the mark on the inside of the caseing(near the top).The points should just start to open at this point.Try placing a narrow strip of paper between the points and ,with slight tension on the paper ,rotate the rotor until the paper slips out.At this position the points are just opening.Adjust points until they open when marks align.That's it.G'luck Trommy
Point the intake cam lobe down and the timing mark on the cam gear at the 12 o clock position with the piston at TDC.
I have a 1998 honda 300ex that needs the timing set how do i do that
How to set timing on 1984 Honda 200s 3wheeler
Timing is set by the ECU.
line up the t mark on flywheel. Then line up stamp on timing gear on cam with indent on top of head.
how do you adjust the timing on a 1988 honda xr200
To set timing correctly on a 1992 Honda Civic the distributor must be installed at the right angle. Install the distributor at the correct degrees to ensure the timing is set properly.
how do i check the timing on my 02 honda 350 atv
i set the timing and cant get my xr80r to start?
The timing is controlled by the computer. There are no adjustments for the timing
i have a 94 Honda passport, my engine is a 3.2L with coil packs. the timing is non adjustable. on the 3.1L the timing indicator is located at the front of the engine by the crankshaft pulley. the timing set is 10-degrees BTDC @ 800rpm. disconnect the set timing connector at the distributor.
Check out my bio page for help on setting your timing.