0
To set the timing on a 1991 Geo Metro, first ensure the engine is at operating temperature and then turn it off. Locate the timing mark on the crankshaft pulley and the timing indicator on the engine block. Use a timing light to check the timing while the engine is running; adjust the distributor slightly if necessary to align the timing mark with the specified degree for your engine model. Finally, recheck the timing after any adjustments to ensure accuracy.
What else can I help you with?
Set timing Geo Metro 1992?
my book says 5 degrees BTDC
How do you set the ignition timing on a 2000 Geo Metro?
Turn the distributer to the right very slightly
How do you set the ignition timing on a 1998 Geo Metro 3-cylinder?
Probably computer controlled and not adjustable
In the ignition system of a 93 Geo Metro 1.0 where should the dwell on the points be set?
electronic ignition on the 93, no controll. just set your timing.
How do you set the timing on a 1991 Geo Storm 1.6 after changing the timing belt?
I think that after you put on the timing belt alighned properly,that your distrib. makes up the diff. when you adjust it. Jim
How to replace a broken timing belt and to set timing marks?
how do you set timing on a 92 geo prizm if timing belt has broken
How do you set the timing on 1991 Chevy c2500 5.7 liter?
set timing on 1991 c2500 5.7 liter
How to set timing on 1991 Ford Escort lx 1.9?
"How to set timing on 1991 ford escort lx 1.9?"
How do you set the timing on 1994 Geo Tracker?
It isn't adjustable. It is controled by the computer
How do you set the timing on a 1991 Ford Ranger after the timing belt breaks?
where to set timing for a 1988 ford ranger 2.2l
How do you set the timing on a 1999 Chevy Metro LSi?
timing does not need to be set on the 1.3l engine in model year 1999 as it is a distributor less igniton system all timing is done by the ecm
How do you set the timing in the distibutar in a 1992 Geo Tracker?
To set the timing in the distributor of a 1992 Geo Tracker, first, ensure the engine is at TDC (top dead center) on the compression stroke for cylinder one. Then, loosen the distributor hold-down bolt to allow for adjustment. Rotate the distributor until the timing mark aligns with the specified timing degree on the engine's timing scale, and then tighten the bolt. Finally, recheck the timing with a timing light to ensure it’s set correctly.
