answersLogoWhite

0


Best Answer

You dont, timing is adjusted by the computer. You can only align the timing marks on the sprockerts and crankshaft. Actually you can,true timing advancing is made by the computer, but initial setting has to be made to ensure proper acceleration, if you dont , the car will reheat or advence poorly on low gears. +5-10 degrees will do fine for most, but its better to find the specific one for your car

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you set the timing on a 1999 Daewoo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the Timing Belt in a 1999 Daewoo Laganza?

look at how to set timing mark for 99 daewoo,explained it there


How do you set the timing on a 1997 Daewoo Ceilo?

you dont its preset by the timing belt


When should timing belt be changed on Daewoo Nubira 1999?

Less then 60,000km


1999 Daewoo Leganza Timing Diagram?

i have uploaded the timing diagram to the following address http://www.savefile.com/files/1572016


How do you change and set the timing belt for a 2000 Daewoo Lanos?

Get a shop manual on it from AUTOBOOKSONLINE.COM


Need to no were timing mark is on crank pulley on 1999 daewoo nubira?

Check the crank shaft pulley


How do you set a timing belt for a 2001 Daewoo Leganza?

i have uploaded the timing diagram to the following address http://www.savefile.com/files/1572016


How to set timing on 1999 Ford Expedition?

how do you set or check the timing on a 99 ford expedition?


Where do you set the timing marks on a 2000 daewoo?

the two cams must be at 12oclock and the crank must be at 6oclock


How do you set the timing on a 1999 jaguar XJ8 engine?

where are thev timing markson a 1999 xj8 jaguar


Where is the ecu on a Daewoo matiz 1999?

where is the ECU on Daewoo Matiz 1999


How do you set the timing on a 1999 Chevy Metro LSi?

timing does not need to be set on the 1.3l engine in model year 1999 as it is a distributor less igniton system all timing is done by the ecm