0
Just follow The Rubik's Cube solution guide instructions I added in the related links section.
It's a 7 steps solution for beginners. steps 4-7 walking you through the last layer solving of the Rubik's Cube.
Good Luck!
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What would give you a 360cm3 volume of a cube?
You have to solve the following equation: x3 = 360cm3 x = 3sqrt(360cm3) = 7.11cm. That is, a cube 7.11 cm in length. Note that you have to take the 3rd root of 360 to get the answer.
What is the cube root of 729 to the 3rd power?
The cube root of 729 to the 3rd power is 729
Resident evil 4 code veronica what do i use the cube for when i have chris?
You use the cube in order to solve the puzzle where Alexia was awakened. When you solve the puzzle, put in the cube. Then, you will see a cutscene and see Alfred come out of the capsule, dead. Go to his dead body and pick up the blue jewel or Alfred's jewel if you examine it.
What is the sum of the 3rd cube number and the 4th cube number?
68
What layer below earths outher layer?
The layer below the earth's outer layer is mesosphere. It is the 3rd layer.
What is the 3rd layer of the atmosphere?
The mesosphere is the third layer of the atmosphere.
What is the cube of 35?
35 to the 3rd? That would be 48275.
Cube of 5?
5 to the 3rd? That would be 125.
What is the capacity of a cube with a side length of 6 cm?
Since the formula for volume of a cube is s to the 3rd power, the answer would be 6 to the 3rd power, which equals 216
Is it possible for you to fix your Rubik's Cube some way easy?
You can fix it if only the pieces fell off, but if a center square broke off, well, that's a lot harder, and you might possibly have to buy a whole new one. However, if you just need to put the pieces back, you should start with an edge piece and put it in place. NOTE: PUT IT TOGETHER SOLVED OR IT WILL MOST LIKELY BE IMPOSSIBLE. To put an edge piece into place, slip it under two center pieces by the protruding sections so it looks like a normal cube edge. Then put another edge piece in right next to it (between two center squares). Next, you need to slide the right corner piece in between the two edges you already put in, making sure the right color is facing down. Next, slide the right edge piece on top of the corner. This should have a 2x2 block on one corner.Continue to put pieces in place on another corner of the cube center. You should put all the pieces on all but one side on. The last side is a bit tricky. To get an edge piece on, you will have to snap it into place instead of sliding it in from the side. Snap the pieces into place in this order:p.s. you should put an edge piece in last, not a corner.-------------| 7 | 1 | 2 ||---|---|---|| 8 | x | 3 ||---|---|---|| 6 | 5 | 4 |-------------NOTE: THE CUBE IS VERY UNSTABLE WHILE SOME PIECES ARE OUT OF PLACE. TAKE CARE NOT TO BUMP IT AND *CRASH* AND HAVE TO START ALL OVER AGAIN. :)
How do you calculate volume for a cube?
You just cube the height....like height to the 3rd power (height*height*height)
How is the volume of a cube affected if the dimensions of the cube are tripled?
Volume is proportional to the cube (3rd power) of the linear dimensions.If the side of the cube is tripled, the volume increasesby a factor of (3)3 = 27 .
