The buzzing is from a loose winding that is moving. The best way is to throw the unit away and get another unit. The other alternative is to break he unit open and paint the coil.
No, the 12 VDC light must have a DC supply and the transformer voltage as well as being 16 volts which is too high, the output is AC.
The output of a 12 volt transformer is an alternating current (AC). Your adapter is a 12 volt transformer but it has a built in half wave or, more expensive ones, a full wave bridge rectifier. What this rectifier does is change AC to DC. Bridge rectifiers are cheap to purchase. Connect it to the output of the 12 volt transformer and you will get a DC voltage. Great little project.
To power ten 12 volt 10 watt lights, you would need a transformer with a total output of at least 120 volts and 100 watts.
All you have to do is change the bulbs to 12 volts and supply the trailer with a 12 volt power source. If you leave the original 24 volt bulb in the trailer they will only glow at 1/2 of their rated wattage.
Change the trailer light bulbs to 24 volts and supply a 24 volt source to power them, in that order.
No, it will destroy the 3 volt device.
Use a voltage devider or a transformer.
Step down transformer.
No, the 12 VDC light must have a DC supply and the transformer voltage as well as being 16 volts which is too high, the output is AC.
Reduce the primary voltage and the secondary will also drop.
The output of a 12 volt transformer is an alternating current (AC). Your adapter is a 12 volt transformer but it has a built in half wave or, more expensive ones, a full wave bridge rectifier. What this rectifier does is change AC to DC. Bridge rectifiers are cheap to purchase. Connect it to the output of the 12 volt transformer and you will get a DC voltage. Great little project.
Look at it and find its weight. If it is heavy it contains a transformer and is dimmable. If it is very light and obviously contains no transformer, it can't be dimmed.
To power ten 12 volt 10 watt lights, you would need a transformer with a total output of at least 120 volts and 100 watts.
All you have to do is change the bulbs to 12 volts and supply the trailer with a 12 volt power source. If you leave the original 24 volt bulb in the trailer they will only glow at 1/2 of their rated wattage.
If it is AC then you don't need a formula, you just need a transformer.
The amp rating for a 100VA transformer will vary depending on the actual voltage of the transformer. Transformers have both a primary and a secondary voltage.
Change the trailer light bulbs to 24 volts and supply a 24 volt source to power them, in that order.