0
Where do you think the play is,it could be anywhere along the steering system.But try the ball joints on the steering rack,the u/v joint on the steering rack to steering column.And also watch for u/v joint on the inside of the bulk head on the steering column.and bearings on the steering column behind the steering wheel all points of wear.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why did your steering wheel mounted radio control buttons stop working?
The wires through the steering column and the rotating connections probably have a break or a bad connection. the steering wheel may have to be pulled to find the cause.
There is a chime when you turn on your headlight that won't stop how can you stop the chime?
on the left side of the steering column is a knob that controls the lights. Pull it of push it until the beeping stops
What does it mean when your steering becomes heavy and your battery light comes on in a ford fiesta?
Alternator Belt has snapped, causing you alternator to stop charging causing you battery light to come on, but this belt also runs your power steering pump which if that's not working your steering will become heavy
What could be wrong Replaced the steering column and the steering wheel just spins?
it could be the shearing pin fitted in most cars to stop thieves breaking the steering lock, could have been damaged when you took it out, or the splines on the lower knuckle joint not connected
Why would blinkers and hazard lights on a 1997 Dodge Intrepid stop working?
u need to replace with a turnsignal light switch . there is a short in steering column
Why did the cruise control and horn stop working when the fuses are good on a 2001 Chrysler Sebring?
The most likely common cause is a failed clockspring in the steering column.
Erratic shifting mercury villager 2001?
My mechanic says the problem might be inside the steering column, some plastic parts and gears or whatever. I thought it might be a cable or the tranny. He says no, its where the shift lever contacts the actuators in the steering column. Bottom line, either get the innards for the steering column and pay to have them changed, or change the whole steering column. The problem has plagued mercury's for ever. Marquis were "shifting from park into reverse all by themselves, and rolling over children in the driveway". I stopped at a sausage cart the other day, and was standing there waiting for my food, and the lady said, "Your van is rolling away." I had to catch it, and then stop it, then get into it and try to shift it into park. The fix, is new parts inside the column, or a new column. Why? Because, sometimes the shifter sticks in park, and people reef on it to get it into gear, and the plastic parts inside the steering column break. Sometimes it is hard to find DRIVE. I think I'm in drive but really I'm in 2nd. So I keep looking for a new steering column, so I can get the parts, or replace the whole column. It's really a time bomb.
Where is the fuel cut off switch for a 1999 Toyota tacoma?
The fuel cut off switch is used to stop the fuel from going to the engine. The fuel cut off switch is located in one of three places. It is either located under the dashboard, near the steering column, or it is located near the steering column or near the engine's firewall.
What would cause your blinker to stop working you checked the fuses and flasher?
Next check the turn signal switch inside the steering column. check to see if the bulb is dead
1992 gmc sierra brake lights notworking good fuses but no brake lights after trucks steering column was broken in theft what could be the problem?
Check stop light switch at top area or brake pedal - maybe damaged when column broken
Your turn signal and hazard stop working on your 2000 sebring convertible?
If your fuses have checked out to be good, you'll need to check your relay, located on the steering column. First you'll have to remove the top steering column cover. It is held on by two screws, which are located on the bottom of the column. Remove the two screws, and pull the top, steering column cover off. Now, look for a small, black box. This is the relay. It is removed, just by pulling it out. It has appoximately five prongs on the bottom. After removing it,you may be able to tap the relay firmly, put it back, and it may work. Recommended, replace with new relay.
How can you stop clocking up mileage on your fiesta?
dont drive it?
