Disconnect the pump from the power, disconnect the pump and motor from the Plumbing, disconnect the motor from the pump, By now you should be able to pull the pump apart the impeller is the double disc with the water ports in it, These need to be cleared if there is any thing in them clear them and put it back together. Good luck.
To keep your swimming pool clean you will need a filters and a water pump. A vacuum would as be a good idea.
Check the pools filtration system - Ensure that your filtration system is appropriate for the size of your pool. If you do not know the correct size for your specific pool, consult a pool expert. Replace the system if necessary. If the current system is adequate, clean out the filter (clean the cartridges or backwash) and empty the pump basket and skimmer baskets to re-establish proper flow to the pool.
No, a pool pump should not run without a strainer basket. The strainer basket helps to catch debris and prevent it from entering the pump, which can cause damage or reduce efficiency. Running the pump without it can lead to clogs, overheating, and potential pump failure. It's essential to keep the strainer basket in place and clean to ensure optimal pump performance.
You don't backwash a pump, you backwash sand and D.E. Filters. To clean them you change your valve to the backwash setting. To clean a pump basket you turn off the pump, open the lid and pull the pump basket out, dump the contents and place it back into the pump and replace the cover. You may or may not need to prime the pump before you turn it back on.
To apply Magic Lube to a pool pump basket gasket, first, ensure the pump is turned off and the basket is removed. Clean the gasket and the area where it sits to remove any debris or old lubricant. Apply a thin, even layer of Magic Lube directly onto the gasket, ensuring it covers the entire surface. Reinstall the basket and check for any leaks when the pump is turned back on.
I clean my filter and skimmer basket and leave my pump running. I do not cover my pool. I guess it could depend on the weather in your area and if you have a problem with leaves getting in your pool.
Normally there are 2 baskets before the pump, One behind the skimmer and one on the pump. However If you only have the one basket then you will have rubbish caught in the impeller of the pump, You will have to take the pump apart and clean the impeller out.
You should never run a swimming-pool pump dry! The most likely problem, from the rather flimsy evidence in your question hinting at it not rotating, is not with the pump or its motor but a fault in the electrical supply to the pool plant, or in the timer or other pump controller.
The purpose of a swimming pool heat pump is to rise the temperature of the water. The pool then can be used for swimming even on days when the weather is not perfect. The swimming pool season is extended.
maybe your pump motor is overheating or running super hot and possibly kind of melting it. Or maybe their is air in the hoses and it is being ruined by forceful Well, the pump has been running dry for days. If it has warped the pump lid then it has warped anything within15" of the pump pot - that is the pipes, fittings into the pump, the pump basket, the pump pot that the basket sits in, the pump seal, impeller. All are probably trash.
When choosing a pool pump for your swimming pool, consider the size of your pool and the flow rate needed for proper circulation. It is recommended to select a pump that can circulate the entire volume of your pool in 6-8 hours. Consult with a pool professional to determine the appropriate size pump for your specific pool size and needs.
form_title= Intex Pool Pumps form_header= Swim your summer away after you buy an Intex pool pump. What is the square footage of your swimming pool?*= _ [50] Is your pool a salt water pool?*= () Yes () No How often do you clean your pool?*= _ [50]