sandpaper/gasoline
To load paper in a Canon PI-DHV calculator, first, ensure the calculator is turned off. Open the paper compartment cover, then insert a new roll of paper, ensuring the paper feeds from the bottom of the roll and over the top. Pull the paper out a few inches, close the compartment cover, and finally, turn the calculator back on to ensure the paper is correctly loaded and aligned.
To feed paper in the Sharp Calculator EL-2192, first ensure the calculator is powered off. Open the paper compartment by sliding the cover, then insert the paper roll with the printed side facing up and the end of the paper positioned under the printer mechanism. Once the paper is in place, close the cover and power on the calculator. Press the "Feed" button to advance the paper if necessary.
To replace the paper in a TI-504511 calculator, first ensure the calculator is turned off. Open the paper compartment by lifting the cover, then remove any existing paper roll. Insert a new roll of paper, ensuring that the paper feeds from the bottom of the roll and over the top. Finally, pull the paper through the output slot, close the compartment, and turn the calculator back on to start printing.
Metho Spirits or a sponge and Detergent
Why would you put on paper?? But anyways try putting the paper under water and that should take it right off!
To replace the paper roll on the Sharp EL-1801P, first, turn the calculator off and open the printer cover. Remove the old paper roll by pulling the paper out of the printer mechanism and detaching it from the spindle. Place the new paper roll onto the spindle, ensuring that the paper feeds from the bottom, and then thread the paper through the printer's paper path. Finally, close the printer cover and turn the calculator back on.
The quickest way is to multiply the original number by 0.9
On a regular calculator, you just leave it it will off itself. On a scientific calculator, press shift AC.
On normal calculator, press 'Off'. If your calculator doesn't have this button, the calculator will turn off automatically after some time. On scientific calculator, press 'shift' and press 'AC'. (depends on your version of the calculator)
Take the paper clip off and make it smaller.
Put the paper outside and take the paper away one by one
sand paper