0
What else can I help you with?
Can you take apart the Nerf longstrike after putting on the cocking mechinisem safly?
yes i hate long strike
Can you take apart the Nerf longstrike after putting on the cocking mechinisem?
yes u can i used the back of a hamer to "pop" it off
On the Nerf longstrike can the stock come off after you put it on?
Not in less you open it up and take out the locks
How do you assemble Nerf longstrike?
Push the back prongs into the slots of the Longstrike. Then, take the barrel extension and rotate it to about a 120 degree angle. Insert it into the slot and push it in.
Nerf longstrike shoulder stock out?
there are two ways you can take a longstrike stock out the first one is to take apart the gun and remove the stock or you can mod it by filing or sanding down the front grooves of the stock. you can check on how to do this on youtube. hope this helps.
What upcoming new Nerf gun is better-the Nerf Long-strike or the Nerf Deploy - Which one has better range-rate of fire- reloading- etc?
My opinion I would definently choose longstrike
How do you take apart a Nerf longstrike?
To take it apart you have to unscrew all the screws on one of the sides and it should come apart.
Can you take off the barrel from the Nerf longstrike?
you can but it is hard you have to take apart the gun and pull the stock up and close the gun
How do you take out air resticters out of a Nerf gun without taking it apart?
You can't. In a nerf gun, there is a safety mechanism to prevent the gun from being too powerful. If you want to take the air restrictor out, then you have to take the gun apart. Hope this helped
How do you take the 35 dart round drum out of the Nerf raider cs-35?
Just pull the cocking thing back all the way and press the button on the right then pull the drum out. Happy Nerfing!
Can you take the stock off a longstrike cs6?
NO!
Can the stock of a Nerf longstrike come off?
You can, although you will have to screw the entire weapon open, take out the stock, and close the weapon again. It's a tough job for a newbie, but someone experienced with taking apart things, E.G, an enthusiast gearhead, should be able to do it.
