answersLogoWhite

0


Best Answer

how to take off an emissions coil on a 1994 geo prizm

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take off the emissions coil on a 1994 geo prizm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix the fuel door for a 1994 Geo Prizm?

You have to take it apart to determine what is wrong before you can fix anything.


How many fuel filters on a 1994 geo prizm?

Take of the front tire, driver side. The fuel filter is right there.


How do you replace the ignition coil on a 1994 caprice?

take the air filter housing off on left side the ignition coils


Where are the back 4 spark plugs on a 1994 Cadillac eldorado?

You have to take coil packs off and then they are easier to get to. You will see the wires going to the plugs.


How old does your automobile have to be before you have to take it to emissions?

It depends on the state, but in Arizona, you have to take it in for emissions when you register for the fifth year.


How do you change ignition coil on suzuki Verona?

Take off the plastic engine cover , take out the bolt that hold the coil , take out the coil.


What can you do to save the environment from petrol emissions?

Buy a lower emissions vehicle or take public transportation.


How do you remove a lock cylinder from a 1994 Geo Prizm?

Take the door panel off, remove the moisture barrier and access it from the inside of the door. Should be a large metal clip holding it on to the door. Of course, you'll have to disconnect the lock rod from it too.


Are there ignition relays that could burn out and prevent starting on 1994 Chevy astro van?

yes, they are in the distributor. Take the cap off, remove the rotor and there it is. The problem could be a bad coil


How do you replace the coil packs on a 1994 ford crown Victoria?

the coil packs are held on to the brackets buy either a seven mm or 8 mm bolts on each side of the coil packs. if you have the twin packs on each side of the motor. now if you have to take the bracket off the you got, i think, 14mm and 15mm bolts down on the face of the heads.


How do you replace a 1970 Chevy ignition coil?

take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.


When emissions gone in the engine of car what does this mean?

I would take that to mean the equipment that cleans up the vehicles emissions is removed from the engine.