0
What else can I help you with?
How do you get a radio out of a 2002 pontica Montana?
take out the radio , take out the ash tray, there are 2 screws to take off face plate off, once you have the plate off you can see there are 2 screws holding it in place remove them , when you pull it out the wire connectors have locking tabs on them, just be care full not to break them . and you can not put them in wrong or backwards how this helps
How difficult is it to replace your car stereo?
Replacing a car stereo is not a difficult process. All you need to do is take off the face plate, unscrew the radio, and unhook the wires. Then place the new stereo in, hook up the wires, screw the new stereo in, and replace the face plate.
How do you replace stereo in 2000 Saturn?
Depending on wich Saturn its really easy just pop off the dash around the radio remove the screws take out your radio unplug the wires and buy a new radio w/ wiring harness and face plate.
How do you remove the stock radio from a 2008 Colorado?
You have to gentle take the face plate off the front part of your dash. The face plate goes around the radio and the air conditioning controls. There are about 6 clips one on top 2 on each sides and one on the bottom. A flat head screw driver works well. Once you pop that off disconnect traction control, (4x4), and hazards from back of panel. Then there will be some screws holding the radio in take those out and the system should just slide out.
How do you take out the radio for a 2003 9-3 Saab?
1st you would need to know if the car is a 93 convertable or sports sedan. If the sports sedan, when you say radio...do you mean the face plate on the dash that you see..this is the ICM...the radio component or the ecm is in the dash...
How do you pull out a radio out of merc clk200 on a 51 plate?
take the dash out and then pull the radio by hand there should only be clips holding it in its very easy to pull as radio
What is the function of the face plate on the sewing machine?
The face plate is the vertical plate on the left side of the sewing machine. It is a protective covering for the needle bar and thread take-up mechanism. See the diagram linked below for a visual.
How do you remove the stereo in 98 firebird?
remove the trim plate around the heater control radio assembly take the three screws out of radio to dash brackets slide radio out and unplug it
Why did Team Rocket take over Goldenrod Radio City Tower?
Team Rocket took over the radio tower because they wanted to use the radio to get the message to Giovanni, their missing boss, that they had reformed.
How do you remove the fuel gauge on a Fiero?
Take the gauge face plate off, pull the gauge out.
How do you take a radio out of a 2000 Pontiac sunfire?
# Disable the airbag system # Remove the accessory trim plate # Remove the radio retaining screws # Pull out the radio and disconnect the electrical connections and antenna lead # Remove the radio from the car
How do you remove dash face plate on 1999 Nissan Quest?
In order to remove the dash face plate on a 1999 Nissan Quest, you need to put on the parking brake, shift into a lower, open the ash tray, and remove it. Next, you will need a Phillips screwdriver to take out the screws on the back of the radio, release all the trigger mechanisms attached to the stereo, and then use the screwdriver to remove the mounting bracket.
