Want this question answered?
look for a blown fuse or a wire unplugged under the seat.
There are bolts that you must remove in order to take out the front seats of a 2002 Monte Carlo. There are two in the back of the seat and two in the front of the seat. If you have heated seats you will also have to remove the wires for that before you take the seat out.
actually there is a panel in the trunk 02 monte under the rug near the back seat
There is a little loop on the side of the seats that you can pull down.
grab bottom edge of seat bottom push toward rear of car and lift up seat should come out.
Jon Dorn
I have a 01 Monte Carlo SS and my ground is under the backseat it was profesionally installed but it was pretty easy to do everything in the back just snaps off and snaps back in to place, but when you take the back seat out there is alot of metal and its easy to screw it to the frame of the car.
Sorry I can't help, but I have the same question on a 2001 Monte ........ my seat reclines past the first stop. Thanks
there are pull straps on both sides of the seat that you pull and that section will pull down.
check to see that you don't have a blown fuse in the fiusebox for your heated seats and also make sure all the wires are plugged in under the seat.
check for a bad fuse and also make sure all the plug-ins under the seat are all plugged in . Check the Relay under the seat. Mine went dead and it was the relay
78-87 Monte Carlo is a G-Body GM car that is smaller than a 77-90 Caprice which is a B-Body GM car. The seats in a Monte Carlo will fit in a Caprice, but they may not look quite right. You will need to do bolt location modifications. I would not recommend trying to use a bench seat from a Monte in a Caprice. It is not wide enough.