answersLogoWhite

0

This requires special tools.

To do work:

  • Disconnect battery
  • Go for coffee, this is to allow the airbag deployment system to discharge.
  • There are screws holding the steering wheel air bag to the wheel. Take them out
  • Work carefully and disconnect the air bag wiring Do not break the connector.
  • Remove the retaining nut on the steering shaft.
  • Mark the wheel and shaft so it will be aligned correctly at reassembly.
  • Use the special steering wheel puller to remove the wheel

Assembly is reverse of disassemble.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What does light on steering wheel mean on 2008 Toyota corolla?

There is no light on the steering wheel.


Where is the fuse for 2008 crown Victoria cigarette lighter?

On a 2008 Ford Crown Victoria : In the fuse panel below and to the left of the steering wheel , by the brake pedal : ( fuse # 16 is a 20 amp fuse for the cigarette lighter and OBD II )


How to remove steering wheel off a 2008 ford F 250?

Remove the steering wheel ford f-250


Where are the airbag sensors located on a 2008 ram 2500?

in the steering collum behind the steering wheel


How do you remove and reinstall a steering wheel in a Nissan Armada 2008?

To remove the steering wheel from a 2008 Nissan Armada, first disconnect the negative battery terminal to prevent airbag deployment. Next, carefully remove the airbag by unscrewing the retaining screws from the back of the steering wheel, then disconnect the airbag connector. After that, use a steering wheel puller to detach the wheel from the steering column by removing the central nut. To reinstall, reverse the steps, ensuring all connections are secure, and reconnect the battery.


Where is the turn signal flasher located in a 2008 Pontiac g5?

To the left of the steering wheel!


Hyundai santa fe radio color codes looking for steering wheel control wire color?

I need the colors on the wires that is connected to audio controls on the steering wheel on a 2008 Santa fe


How do you remove air bag from steering wheel of Montana 2008?

To remove the airbag from the steering wheel of a 2008 Pontiac Montana, first ensure the vehicle is turned off and the battery is disconnected to prevent accidental deployment. Use a Torx screwdriver to remove the screws located on the back of the steering wheel that secure the airbag module. Gently pull the airbag away from the steering wheel, disconnect the wiring harness, and then fully remove the airbag. Always consult a professional or refer to the vehicle's service manual for specific instructions and safety precautions.


How do you tilt the steering wheel on a 1999 Mazda miata?

Sorry...you can't tilt it! I think they added that feature in about 2008.


Where is the OBD port located on 2008 Highlander?

below the steering wheel, above the brake pedal, there is a white connector


What causes the steering wheel to shake on the 2008 dodge avenger?

Bad tire, bent rim, warped rotors.....


Is there a fuse that controls all the buttons on steering wheel of a 2008 Mercury Mariner?

The buttons function off the "clockspring" inside the steering wheel, that is where they get their power. The clockspring wiring harness may have come loose. If you aren't familiar with these parts, don't try disassembling your steering wheel or you may end up activating the airbag, very dangerous.