First, grip the little solder point and give it a twist. You will free the brass contact and break one of the wires leading to the filament.
You wouldn't use a potato to screw in a light bulb... if the glass in the light bulb breaks as you're removing it, you can use a potato to take the light bulb out.
Define "light bulb"
take out light bulb in a dash
One professional will take 1 second to screw in a light bulb and 0.5 seconds to install a bayonet cap light bulb.
You might have to go in through the trunk of the car to take the light cover and all of that out go to the store ask for a tail light for your model when you get the light DO NOT TOUCH THE BULB!!! This means you have a faulty bulb that you paid for if you touch it. The light bulb reacts with the heat from your fingers and goes faulty. Grab it by the aluminum or the metal at the bottom of the bulb and carefully slide it in back like your old bulb that you replaced try and copy what you saw with the old bulb.
that depends on how high up the light bulb is
It should only take one person to switch on a light bulb if it is 6 light bulbs it may take 6 people to switch on a light bulb Der!
A typical incandescent light bulb can take hundreds of years to break down in a landfill due to its glass and metal components. However, some parts of the bulb, such as the tungsten filament and any hazardous materials like mercury, may still pose environmental risks if not properly disposed of.
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
Remove the light bulb connector from the light. Take hold of the light bulb, push in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
None! as Oranges can't either put up nor light an light bulb! ;)
take bulb out from behind light assembly, under hood. look for wires that is connected to light, this is where the bulb comes out.