0
I just did this and it works, remove radio and ignition switch .find 3 wire connector (we want yellow wire and it is thin) . start car and cut the yellow wire while car is running. you are done this info come from my mechanic auto repair
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What kind of steering fluid do you add to a Chevy Malibu?
I have a2005 malibu and it has electronic steering no fluid needed
How do you tighten the door handle to a 2005 aveo?
how do you tighten the door handle to a2005 Aveo
How do determine which rear axial is in a2005 Chevrolet Silverado?
Vin Code, Call the Dealer and they can tell you
Where is the oil filter on a2005 Chevy Silverado?
on the left side of motor above front driveshaft
Where is the throttle position sensor on a2005 ford explorer 4.0 engine?
The throttle position sensor is mounted on the side of the throttle body
What is involved with a2005 foucus 60000mile service?
they should be changing the oil, air filter, rotating tires, checking brakes, and checking/topping off fluids.
What type of oil is needed for a 2005 dodge neon?
I have a2005 SXT it isFactory Recommended to use 5W20 all climate oil,you can however use 5W30 but I stick with 5W20
How many lugs does f150 forf truck have a2005?
( 6 lugs per wheel / total of 24 lugs ) on a 2005 Ford F-150 The answer seems fine to me ! What's wrong with the answer ?
What is the difference between flame spread index and flame spread rating?
CheckFlame Spread Index. The definition from NFPA 220 is ...www.nfpa.org/assets/files/PDF/ROP/59A-A2005-ROC.pdf
What is the value of a2005 dime with two different colors on each side?
If you were to clean it up and wash the crud off of it so that both sides were the same color, it might be worth the full 10 cents again.
Where is the ac unit located in a2005 Chevy Cobalt?
By unit you may mean the compressor, its the same style as most other cars and can be found in the same place. If its not working check fuses see manual for fuse descriptions
Is there a special tool for the tension on a2005 dodge 3.3 serpentine belt?
the idler pully makes the tension. to remove belt you use a wrench push tensioner in a direction that would loosen the belt as if you were trying to tighten or loosen the bolt holding the pulley on. carefull high tension.
