answersLogoWhite

0

A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you test ignition coil on your Alero 1999?

1999 Alero how do i test ignition coil pack


How do you test a ignition coil with circuit diagram?

You cannot test it with a diagram. You will need a multimeter to test the coil. Click the link.


How do you test ignition coil Volvo s70?

pluginyerarse


How do you test the ignition coil on a 1994 acura integra?

ohm it.


How do you test the coil in 1995 mercury mystique 2.0 l?

HOW DO YOU TEST THE COIL PACK ON A 1995 MERCURY MYSTIQUE DOHC 6 CYL.


How do you test the ignition coil on your 1994 Geo Metro?

Disconnect the distributor cap end of the coil wire and attach to an ignition tester. Attach the ignition tester to a good ground, away from any fuel lines. A good spark tester can be made from an old spark plug gapped to 0.200". Crank the engine and observe the tester for spark. If a crisp blue spark is noticed, the ignition coil is working properly. If a pale yellow spark, or no spark, is noticed, the coil is more than likely bad.


Would like info on ignition troubleshooting for 92 Chevy Suburban?

test ignition coil,ignition module,pick-up coil,electronic spark control,and knock sensor


How do you test a ignition coil of kawasaki rouser 135?

To test the ignition coil of a Kawasaki Rouser 135, you can use a multimeter to check the resistance between the primary and secondary windings. Compare the reading to the manufacturer's specifications to determine if the ignition coil is functioning correctly. You can also visually inspect the coil for any physical damage like cracks or corrosion.


How do you test fire an ignition coil?

You test an ignition coil by checking the resistance with an ohm meter. The resistance values should be something like, Primary winding .3 to 1 ohms, Secondary winding 8,000 to 11,500 ohms.


How do you test a 1989 Chevy Celebrity coil?

If you are not getting spark to any of the plugs could be coil rotor and/or cap HEI ignition?


How do you test ignition coil on 2005 trailblazer ls 4100?

let the engine running, lift off the ignition coil one by one after opening the screw...a tick sounds will be heard ... no tick sound and gasoline leak on the plug thread means the ignition coil is busted.


I have a 91 Geo storm that turns over but no fire from coil?

Try the ignition control module. Had the same problem with mine $36 part fixed it. The ignition control module is in the distributor and so is the pickup coil, but the ignition coil is by the battery. There is a spark test that can be done. If it was already done and couldn't see a spark, then it could be the ignition coil it self , the ignition wire, or any possible electrical connections.