Easiest is to plug in the block heater cord with the hood open. Follow the cord to where the block heater is located and you should hear a gurgling sound similar to an electric kettle. If you don't check your power source. If you can reach the block heater unplug the cord from it and check the power at the end that plugs into the heater with a 2 prong tester to make sure it's not the cord causing the problem.
The Pontiac G6 block heater is located on the right hand side of the engine. The block heater can be located by following the block heater cord.
I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.
Easiest is to plug in the block heater cord with the hood open. Follow the cord to where the block heater is located and you should hear a gurgling sound similar to an electric kettle. If you don't check your power source. If you can reach the block heater unplug the cord from it and check the power at the end that plugs into the heater with a 2 prong tester to make sure it's not the cord causing the problem.
check your answer
On my wife's 2007 G6 GT It was on the battery side near the wire harness. It is a flat cord with a 120 V grounded outlet plug with a rubber cap that had "Phillips and Temro Ind" printed on it.
The only way to test is to have the cord below 0F(-18C)
The Toyota Camry block heater is located on the front of the engine block. You can follow the block heater cord to the block heater.
You can test drive a Pontiac G6 convertible at a local Pontiac dealership. You may also be able to locate a used car dealership that has a Pontiac G6 convertible and be able to test drive the car there.
A block heater is not standard equipment.A block heater is not standard equipment.
To install a block heater on a 1997 Toyota T100, first ensure the engine is cool and disconnect the battery. Locate the freeze plug on the engine block where the heater will be installed, and remove it carefully. Insert the block heater into the hole, ensuring a snug fit, and secure it according to the manufacturer's instructions. Finally, reconnect the battery and test the heater by plugging it in before starting the engine.
The 2002 PT Cruiser block heater is located on the front of the engine block. You should be able to follow the block heater cord to the block heater.
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.