The voltage is measured by high and low range. Measurements are referred to as r.m.s. , switching impulses reflected by line to line, earth to line contact.
the connecting units between an instrument and a process pipe or vessel, the tube is commonly referred to as an impulse tube or impulse line.
what do you mean by TT impulse line hook-up??????
Simply, the voltage which is withstand by the test object as an impulse is called as rated impulse voltage.
csACaca
Yes, an action potential is needed for a nerve impulse to occur.
Yes, an action potential is needed for a nerve impulse to occur.
The impulse line is the piping or tubing used to connect the transmitter to the process. To ensure correct readings, it is essential that impulse lines be installed correctly for the type of fluid that you are measuring. Consult your transmitter installation manual.
The direction of the impulse vector is determined by the direction in which the force is applied to an object. It is always along the line of action of the force. The impulse vector points in the same direction as the force on the object and causes a change in the object's momentum in that direction.
One factor that does not influence the rate of impulse propagation is the size of the neuron. The rate of impulse propagation is determined mainly by the myelination of the axon, the presence of nodes of Ranvier, and the diameter of the axon.
Mock test is necessary to see where you stand during preparations.
If impulse triples and time reduces to one-third of its original value, the force will increase by a factor of 9 (3 x 3 = 9) to maintain the same impulse-force relationship (Impulse = Force x Time). This increase in force is necessary to account for the shorter time over which the impulse is applied.
The lightning phenomena is occurred on transmission lines or sub-stations due to which a negative wave is generated hence definitely destroy the power apparatus. So for impulse voltage testing of any power apparatus one must produce a negative impulse.