0
to test ht lead with out taking it out of coil pack. All you have to do is remove the 1 cylinder ht lead and pull the cylinder 5 ht lead out aswell and measure the resistance with multi meter. so now it will give you the reading. so its 1,5---2,6---3,4 ht leads.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
95 Ford Ranger 4-cylinder 8 spark plug compression test?
pounds of compression per cylinder
Cylinder not firing on 1996 Ford Escort?
Bad spark plug? Bad plug wire? Do a compression test
I suspect a blown head gasket on my 1989 Chevy 1500 with the 350 motor but how can i be sure and which side its on?
You will need to do either a cylinder leak down test or a compression test.
How do you wire a three phase motor if none of the wires are idetified?
If it is a three lead 3-phase motor, it is easy: connect the incoming three leads randomly to the three leads on the motor (one to one) so that there are a total of three splices. The motor will run but possibly in reverse If it runs in reverse, switch any two of the three splices ---- If the motor has more than three leads, and they are not marked, it is much more difficult. You will have to have a working knowledge of how to test the leads and compare the results with the information given on the nameplate
How many test leads are needed to find resistance?
The test equipment needs two test leads to find the resistance in a circuit.
Where are the fuel injectors located on a Ford Escape?
The fuel injectors on the Ford Escape are located on the top of the motor at the center of the engine compartment. You can test the injectors using an ohm meter.
How do you fit a vauxhall vectra clutch MASTER cylinder AND how do you determine if its knackered?
Remove the clevis pin from the pedal the remove the master cyl from the bulkhead A quick way to test the cylinder is clamp the flexible hose that leads to the slave cylinder when the hose is clamped, the clutch pedal should be solid.
Where can someone find reviews on the best test leads?
Test leads such as the Fluke TLK289 have been reviewed on Grainger. They have extensive reviews of many brands of test leads, modular kits and industrial products.
How do you adjust the timing on a multi point injection Ford Falcon 1992?
This is best left to a qualified mechanic with the appropriate tools, such as a timing light and test leads!
How to tell if head is cracked on a Ford escort 1995?
The only positive way to tell if a cylinder head is cracked is to remove it and have a specialist pressure test it.
How do you test motor for burn?
To test a motor, use a megger (megohm meter) to test the insulation of the internal motor windings. Select a voltage to apply to the motor using an output from the megger that is higher that the operating voltage that the motor operates on.
Where can you purchase fluke test leads?
Fluke Test Leads can be purchased at online retailers including Grainger, Test Path, and TransCat. This product can also be purchased at Amazon and eBay.
