there is a small long bolt on the left side of the brake handle tighten the nut to adjust
If the rear brakes are out of adjustment,the hand brake will not work..
There a 2 wing nuts in the back that the brake cables connect to. You need to tighten them up until you feel resistance at the hand lever.
There are 2 bolts on the Bottom of your scooter by the brake, you have to tighten them to your satisfactory. Hard to find a replacement if it snaps.
you need to adjust the rear brakes and that will tighten up the e brake. If that doesnt help, you may need new rear brake shoes.
you need to adjust the rear brakes and that will tighten up the e brake. If that doesnt help, you may need new rear brake shoes.
There is a screw on the hand brake handle inside the cabin. Just take off the leather that is covering your handbrake lever, and you will see it.
I'm finding it hard to stop i think i need to bleed or tighten up the front brake HELP?
To tighten the emergency brake cable on a 1990 Geo Prism, start by depressing the brake pedal. Next, locate the parking brake equalizer bar. Rotate both rear tires to feel the brake shoes slightly drag against the brake drum.
Tighten it
go underneath the vehicle with two wrenches. tighten up the adjust ment nut, it might be on a turnbuckle, or right off the e brake handle
inside the center console there is a little plastic plug on the side closest to e brake. take out the plastic cap and there is a nut in there. tighten that