0
What bolts?
Usually with some sort of wrench!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you tighten a serpentine belt on a 1996 Oldsmobile ciera?
How do you tighten the serpentine belt on an oldsmobile ciera
How do you tighten my chain on a 87 250x ATV?
you can tighten the actual chain but that may be hard to do. my advice is that there shoulbe be some bolts in the swingarms that holg the axle in one place loosen them and move the axle back until the chain is where you want it
What is a wrench that does't tighten bolts?
Every proper wrench will tighten or loosen bolts. -If this is a riddle or joke, please enter it in that category.
Torque specs 4.7 dodge Dakota head bolts?
* Step 1: Tighten bolts 1-10, 20 N·m (15 ft. lbs.). * Step 2: Tighten bolts 1-10, 47 N·m (35 ft. lbs.). Tighten bolts 11-14, 25 N·m (18 ft. lbs.). * Step 3: Tighten bolts 1-10, 90 degrees. Tighten bolts 11-14, 30 N·m (22 ft. lbs.).
What kind of wrench is used to tighten nuts and bolts to a specified amount?
A torque wrench is used to tighten nuts and bolts to a specified amount
How do you tighten drive chain on 87 Honda trx250x?
undo pinch bolts, rotate cam clockwise (that's the big housing that the axle runs through) and tighten pinch bolts again. Its not a cam its called the carrier and you would turn towards the front of the ATV to tighting, still allow the chain to have some slack 3/4 inch
How do you tighten chain on 2003 Suzuki z400?
Loosen the top two bolts on the swing arm, after tighten the two bolts on the rear of the swing arm until you have 1.5"-2" of slack. Tighten the top bolts back up and good to go
What is spanner used for?
To tighten bolts and nuts
Torque specs big end bearings Toyota 3l 2.8l diesel?
For new bolts(1st time) tighten to 34nm, then tighten a further 120degrees For used bolts(2st time) tighten to 54nm, then tighten a further 90degrees
What is head bolt pattern for 2006 4.7 liter Dodge?
he cylinder head bolts are tightened using an angle torque procedure, however, the bolts are not a torque-to-yield design. 6. Tighten the bolts in sequence using the following steps and torque values: Step 1: Tighten bolts 1-10, 20 N·m (15 ft. lbs.). Step 2: Tighten bolts 1-10, 47 N·m (35 ft. lbs.). Tighten bolts 11-14, 25 N·m (18 ft. lbs.). Step 3: Tighten bolts 1-10, 90 degrees. Tighten bolts 11-14, 30 N·m (22 ft. lbs.).
87 Oldsmobile 98 not a cutlass?
No. It's a 98. Not a Cutlass.
Bolt pattern on a 2003 Oldsmobile intrigue?
Which bolts?
