Tighten each one uniformly just until they stop, any further and you squeeze out the gasket, any less and it leaks.
no, use rtv sealant
the valve cover gasket is loose and or worn out, try to re-torque the valve cover or replace the gasket
remove the valve cover pull off the valve cover gasket and put new one up making sure you dont over tighten the valve cover bolts make sure you have correct torque replace all the o rings inside valve cover while changing main gasket for best results
89inch pounds is the torque rating for the valve cover bolts
how do you replace the valve cover gasket on a 2002 mitubishi lancer
The valve cover gasket, on a 2004 Jeep liberty, can be found by removing the valve cover. Peel the gasket off of the head and replace with a new gasket.
remove the 10mm bolts from the edges and clean all surfaces VERY CLEAN and replace gasket and then torque the bolts back not sure of the lbs to torque to good luck it is not hard to do
remove the 10mm bolts from the edges and clean all surfaces VERY CLEAN and replace gasket and then torque the bolts back not sure of the lbs to torque to good luck it is not hard to do
What is a oil cover
valve cover torque 98 nissan2.4
The valve cover ask it, on a S 40 Volvo, can be replaced by first removing the valve cover. Remove the old gasket and replace with a new gasket.
More than likely you have a valve cover leak. You probably need to replace the gasket(s).