Battery first. Will it start with a jump? Battery ok, then use a test light & see if you have current in the hot wire to solenoid when key turned. If you do, it's the starter. If not maybe the switch but start there.
autozone.com
You have to remove it gently and go to auto zone and turn it in
To troubleshoot a 1983 Mercedes-Benz 380SL that cranks but has no spark, first check the ignition components, including the ignition coil, distributor cap, rotor, and spark plugs for wear or damage. Ensure the ignition system is receiving power by testing the battery voltage and fuses. Next, inspect the crankshaft position sensor and ignition control module, as failures in these parts can disrupt spark generation. Finally, verify connections and grounds to eliminate any wiring issues that could prevent the ignition system from functioning properly.
the ignition timing does not get replaced on 87 dodge.
Dodge City - 1983 VG was released on: USA: 1983
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
where is the ignition module located in my 2000 dodge 1500 ram van
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
It should have electronic ignition.
Possible causes for a 1983 Dodge D150 pickup not firing when trying to start could include issues with the ignition system (such as a faulty ignition coil or distributor), fuel delivery problems (like a clogged fuel filter or failing fuel pump), or issues with the starter motor. It is also advisable to check the spark plugs and wires for any signs of damage or wear.
Ignition module or fuel pump
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.