Bring it to a shop that has an ABS Scanner
the brake light switch is on the top of the brake pedal arm. under dash.
the switch is located at the top back of brake pedal!!
go into your trunk and you will see little black tabs on the inside un screw those tabs the brake light will then pop right out...
Replace them.
The emergency brake is partially depressed, even though the brake light is not on. release with handle and pull up on the brake pedal.
You will need to remove the 1998 Chevy Camaro brake light wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light.
The 1998 Nissan brake light switch is located below the dashboard, on the drivers side of the engine compartment. The brake light switch simply plugs in and out.
Have vehicle scanned to determine the problem
brake light on dash blinking
My 1998 Malibu had the same problem. The reason that it is on is because your brake sensor is located in your wheel bearing, and most likely your wheel bearing is worn out. I replaced both front wheel bearings and the ABS light is no longer on.
use your parking brake this answer is in the owners manual
You can tell if the transmission, in your 1998 Chevy Malibu, is going bad. If there is a whining or clunking noise. The transmission might cause your engine to install when you are stopped with your foot on the brake.