0
1st Good swimers only! Dangerous!
Make sure engine has stopped. Sounds dumb but I have seen them run for 5 minuteds inverted.
DO not put your fingers or toes IN ANYTHING including Jet intake, cooling ports, control cables and so on.
Try pushing down on and steping up on the near side bump rail, as the machine rolls up reach over and grab the far bump rail, as you sink and the machine rolls keep you hands on the bump rail and allow the machine to push you away. If you allow your elbows to flex too much the machine will bash you in the face, if you don't flex your elbows you will injure shoulders, wrists etc.
Large machines may require steping on the handle bars, DANGEROUS! You are risking tangling feet in controls.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What happens when a PWC steering controls is turn to the right?
The back of the PWC is pushed to the left when a PWC's steering control is turned to the right.
A PWC capsizes. What is the best way to roll the PWC to turn it upright?
When you capsize a PWC you should always follow the label on the back when rolling it back over. Most PWCs now include a decal that tells you which direction to turn the watercraft back up. If they do not include this label you would have to try to find an owners manual for that specific PWC. When it comes to actually turning the watercraft I find most success in getting to one side of the PWC and pushing down on the near side. Then after it begins to roll I will grab the opposite side (by where your feet go) to pull that towards me. It is almost like trying to climb it without going anywhere, but the PWC will roll. This must be done carefully and depending on the size of the PWC and the former rider(s). I am a larger person with a small 2 person PWC and I manage doing it this way just fine. When it is upside down you should attempt to flip it back ASAP along with running the bilge when back upright to pump the water out of the hull. I also check for any weeds by peeking at the water intake while its upside down. Reminder: Proceed with caution while flipping your PWC back upright. It can roll on to you and always make sure that the engine is not running (if the kill switch worked properly).
A PWC capsizes What is the best way to roll the PWC to turn it upright?
When you capsize a PWC you should always follow the label on the back when rolling it back over. Most PWCs now include a decal that tells you which direction to turn the watercraft back up. If they do not include this label you would have to try to find an owners manual for that specific PWC. When it comes to actually turning the watercraft I find most success in getting to one side of the PWC and pushing down on the near side. Then after it begins to roll I will grab the opposite side (by where your feet go) to pull that towards me. It is almost like trying to climb it without going anywhere, but the PWC will roll. This must be done carefully and depending on the size of the PWC and the former rider(s). I am a larger person with a small 2 person PWC and I manage doing it this way just fine. When it is upside down you should attempt to flip it back ASAP along with running the bilge when back upright to pump the water out of the hull. I also check for any weeds by peeking at the water intake while its upside down. Reminder: Proceed with caution while flipping your PWC back upright. It can roll on to you and always make sure that the engine is not running (if the kill switch worked properly).
What happens when you turn a pwc's steering control to the right?
When turning a PWC steering cable right it will go left. If you turn it left it will go right.
What is the best way to roll the PWC to turn it upright?
When you capsize a PWC you should always follow the label on the back when rolling it back over. Most PWCs now include a decal that tells you which direction to turn the watercraft back up. If they do not include this label you would have to try to find an owners manual for that specific PWC When it comes to actually turning the watercraft I find most success in getting to one side of the PWC and pushing down on the near side. Then after it begins to roll I will grab the opposite side (by where your feet go) to pull that towards me. It is almost like trying to climb it without going anywhere, but the PWC will roll. This must be done carefully and depending on the size of the PWC and the former rider(s). I am a larger person with a small 2 person PWC and I manage doing it this way just fine. When it is upside down you should attempt to flip it back ASAP along with running the bilge when back upright to pump the water out of the hull. I also check for any weeds by peeking at the water intake while its upside down. Reminder: Proceed with caution while flipping your PWC back upright. It can roll on to you and always make sure that the engine is not running (if the kill switch worked properly).
You are operating a PWC. You are heading straight toward a dock. You turn the engine off and then turn the steering control hard right. Which way will the PWC go?
It will Continue Toward The dock
Which function on a PWC will not operate at idle speed?
You will not be able to turn .
You are operating a pwc you are heading straight toward a dock you cut the throttle to idle and then turn the steering control hard right which way will the pwc go?
You are operating a pwc and you are heading straight toward a dock, you cut the throttle to idle and then turn the steering control hard right so the pwc will go straight, it has no power this way.
What actions should be taken when a motorboat and a PWC are approaching head-on?
turn left
A motorboat and PWC are approaching head on what action should be taken.?
turn left
A motorboat and a PWC are approaching head-on. What action should be taken?
turn left
If you are on a PWC and heading straight toward a dock and you cut the throttle to idle and then turn the steering control hard right which way will the pwc go?
Straight Toward the Dock!!
