0
You can not. Replacement of the oxygen sensor is the only way.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do turn off check engine light on 1998 Toyota Sienna?
must be a oxygen sensor
Will my check engine light turn off automatically when you replace the oxygen sensor?
It will after a drive cycle, if that was the original problem.
How do you turn off the Engine light for Toyota 1995 Camry?
I am not sure but I think you have to replace the oxygen sensor. Hope this help.
What are 2 ways to power a night light?
You may use a sensor. For example, if you clap the light will turn on. Also a temperature sensor, if the room you are in is cold the light will turn on or off.
How do you get the oxygen sensor light on an 1986 jaguar xjs to turn off?
They are supposed to be replaced every 60,000 miles and are located underneath the chassis by the catalytic converters
How can you disable the check engine light for an o2 sensor?
replace the bad sensor and it will turn off.
Elements most associated with electric light bulb?
How to turn off the backyard sensor light
How do you turn off the service engine soon light on a 1994 Chevy G20?
9 times out of 10 replacing the oxygen sensor will do the trick. Or, try disconnecting and reconnecting the battery.
How do you turn off the service engine light on a 2002 Cadillac Escalade?
"How do you turn off the service engine light on a 2002 cadillac escalade?" When replacing oxygen sensors, will the service engine turn off?
How do you turn off engine check light to Chevy cavalier after oxygen sensor is fixed?
Scan tool or unhook battery.Scan tool or unhook battery.
Why is your engine light onon your 96 Tacoma?
Usually its caused by your oxygen sensor also known as O/2 sensor. Or a missfire caused by water in fuel or dirty injectors. You can turn the light out by disconecting your battery for 10 minutes or longer but not less,this will reset the computer and the light will stay off unless the sensor is bad or you have another missfire.The sensor is located in the exhaust pipe.
Motion detector security lights won't turn off?
In most motion sensor switches you will have three wires. A black, white and red wire. The black and white (neutral) are used for the electronics in the sensor. These connect to the incoming black and white power. Connect the lamp across the red and the white (neutral). When the sensor detects motion the red wire becomes "hot" and the light will go on.
