To turn the key back in an '86 Buick Regal, simply insert the key into the ignition and turn it to the "Off" position. If the key is stuck, ensure the gear shift is in the "Park" position; if it's not, the ignition may be locked. Gently wiggle the steering wheel while turning the key can also help release any tension. If you're still having trouble, check for any issues with the ignition lock cylinder or key itself.
To reprogram a key for a 2000 Buick Regal, you'll need a working key and the vehicle. Insert the working key into the ignition and turn it to the "On" position without starting the engine. After about 10 seconds, turn the key back to the "Off" position and remove it. Then, insert the new key and turn it to the "On" position for 10 seconds. This should successfully reprogram the new key. If you encounter issues, consult the owner's manual or a professional locksmith for assistance.
You have to get it from a Buick dealer.
buick regal
Why is my security light on and will not let my key come out of the ignition. 1999 buick regal
i replaced the steering colomn in 95 buick regal and now it wont even turn over.does the different key that i got with the colomn have any thing to do with it not starting.?
Try turning the steering wheel either to the right or left while attempting to turn the key
with our 98 regal the resistor type key was bad, try your second key if you have one
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
The ignition switch. Where the key goes in is the key tumbler.
Key from the outside Individual slides of buttons on doors
The 2002 Buick regal that I have has a reset switch behind the fuse panel on the right side of the dash board. If you open the panel there is a switch that is red and marked reset. turn the key on hold the switch for 10 seconds and the oil life should be reset. It also rests the tire low indicator.
To replace the ignition key cylinder in a 1991 Buick Regal, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it off. Insert the key into the ignition and turn it to the "Run" position; press the release tab on the ignition cylinder and pull it out. Finally, insert the new cylinder, ensuring it clicks into place, reassemble the steering column cover, and reconnect the battery.