Want this question answered?
You can turn off the 2009 Toyota Camry seatbelt warning light by engaging the seatbelt. You can also remove the seatbelt warning light fuse. Removing the seatbelt warning light fuse is not recommended.
You can turn off the seatbelt warning light in your 2006 Ford Explorer, by buckling the seatbelts. When the seat is occupied the warning light will stay on until the seatbelt is buckled.
Put on the seat belt.
by putting on your seatbelt
Put on your seatbelt!
how about just fastening the seatbelt when no one is using it.......
Unless your seatbelt is on. aswell as other passengers, the seatbelt light will not turn off. It is a safety precaution and I highly doubt you can disarm it.
Yes but when the seatbelt light comes on you have to turn it off! x
- Switch on without starting the engine - Wait till the seat belt warning light switches off - buckle and unbuckle the belt three times ending with the belt unbuckled - Switch on the head lights - Switch off the head light - the seat belt warning light will light for few seconds and once it swiches off buckle and unbuckle the bet one more time - switch off Siamand ORRRR, try fastening your seatbelt. tard
Get in the vehicle and latch the seatbelt. Turn the key to "on" not "start". Wait for the seatbelt light on the dash to go out. Unlatch and relatch the seatbelt buckle 3 times within 10 seconds. Waiting for the the seatbelt light on the dash to come on before each relatch. End with the seatbelt latched. Turn the key to off. A single ding indicates success. Complete the above steps all within 60 seconds. If you hear any dings during the process you must start over.
You just put your seatbelt on,if the light is still on after engaging seatbelt. See your dealer (mechanic) may effect your srs system from functioning properly
To state the obvious - wear the seatbelt. There are reasons to disable the chime. 1. Turn key to accessories "on" 2. Wait for seatbelt light to turn off and then press the seatbelt release button 9 times. 3. The abs light then illuminates for 5 seconds, when it turns off, press the seatbelt release button 1 more time. 4. The abs light will blink to confirm the code was entered. 5. This must also be done on the passenger seat.