Want this question answered?
To turn off the check engine light on a 1999 Toyota Camry you can disconnect the battery. This will only reset the check engine light. So if there is a persistant problem with the engine, the light is likely going to stay on. To turn off the check engine light on a 1999 Toyota Camry you can disconnect the battery. This will only reset the check engine light. So if there is a persistant problem with the engine, the light is likely going to stay on.
Take the 1992 Toyota Camry to receive a diagnostic test. The machine will allow the test to manually turn of the airbag light and also see what is causing the light to turn on.
To reset the check engine light on a 1999 Toyota Camry LE V6, disconnect the positive battery cable for a few minutes. Then reconnect the battery. If the 'check engine' light is still on, then turn the key to on without starting the engine and pump the gas three times and turn the key off. Start the car and the light should be off.
Click the link.
I have yet to do this on my 2005 Camry, but according to the Toyota Tech you must turn the key switch over (do not crank car) the check engine light will appear, now hold down the button on the odometer and at the same time turn the switch off than back on.
Check engine light or required maintenance light. Procedure for resetting required maintenance light just answered. Check engine light requires an OBD II to determine problem and turn the light off.
how do you change turn signal switch on 1999 toyota camry
you just go and get it checked
can be a multitude of things, if the eng. light is not on, start with checking the convertor.
You can turn off the 2009 Toyota Camry seatbelt warning light by engaging the seatbelt. You can also remove the seatbelt warning light fuse. Removing the seatbelt warning light fuse is not recommended.
Opened the 1998 Toyota Camry hood compartment. Take hold of the light bulb connector. Push the connector in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
I am not sure but I think you have to replace the oxygen sensor. Hope this help.