The abs light is on because there is a problem with the abs system. Have the system repaired and the light will clear itself.
tail/stop/turn signal bulb # 3057 park/turn signal bulb # 3157NA
at 8:30 pm by yours truly buck altmeyer 4th grade
According to the 2000 Ford Windstar Owner Guide : The front park / turn lamps take the ( 3157 NAK , amber bulb )
It could be thjat it is not in park. If not put it in park it should start right up.
You can only do this in park ... Turn off your truck ,apply the parking brake and turn your truck back on .
Turn the key to run position Depress the accelerator pedal to the floor 3times in 5 seconds. The light should flash and the go out. Turn the key off and the start the engine.
replace taillight bulbs first. filiment from brake light can break and make a connection to your park light. pressing brake pedal can light up your turn indicators, or even park/dash lights
my 2000 Cadillac Deville did the same thing. all i did was to turn switch off turn car off counted to 60 turn car back .on light has not come back on
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
Turn the key to the on position, wait ten minutes, then it will turn over.
The 2000 BMW shift light is computer programed to go on and off at the appropriate times. You can remove the shift light fuse to keep the light off permanently.
Your Answer: 2000's