0
The 4wd is automatic in the 1992 Subaru Legacy Wagons. There is an empty fuse under the hood that has a cover that says FWD that can be used to disable the 4wd and force it to be in front wheel drive, but by default, there should not be a fuse in it. When there is a fuse in the FWD connector, the dashboard will have a warning light that says FWD, indicating that you do not have 4wd enguaged. If the light is not lit and you do not have 4wd then you have a transmission issue that will likey need the expertise of a transmission specialist. Check the transmission error codes (as opposed the the standard engine error codes.) They will likely help you pinpoint the problem.
What else can I help you with?
How do you turn off awd on a 1998 subaru legacy wagon?
Put a fuse in the circuit labeled "FWD" under the hood on the passenger side.
Where is the Flasher unit 1995 Subaru outback for turn signals?
There is no such thing as a 1995 subaru outback, the outback package was not offered on a subaru legacy until 1996, you either have a 1996 subaru outback, or you have a 1995 subaru Legacy L or LSI wagon. Both will be covered in most guide books you can pick up at your local autoparts store.
Do I need a modulator for a trailer hitch on your 1993 Subaru Legacy in wagon in order for the trailer lights to work?
Yes. You need a converter to combine the turn signals with the brake lights.
No start on a 1996 Subaru legacy?
Does it turn over? Does it have fuel? Does it have spark?
Where is the turn signal relay in a 93 subaru legacy located?
The turn signal relay for the 1993 Subaru Legacy is located behind the left hand instrument panel. Look on the left hand side of the steering column.
How do you reset the alarm system after changing a battery in a 2001 Subaru Legacy GT wagon?
To reset the alarm system in a 2001 Subaru Legacy GT wagon after changing the battery, first ensure that the new battery is properly installed. Then, unlock the driver's door using the key or the remote, which should deactivate the alarm. If the alarm remains active, insert the key into the ignition, turn it to the "On" position without starting the engine, and then turn it back to "Off" to reset the system. Finally, check the owner's manual for any specific instructions related to your alarm system model.
Replace high beam switch 1996 Subaru outback?
how to replace high/low beam, turn signal lever on 1996 subaru outback wagon
Where is the thermostat located on 1990 subaru legacy awd wagon?
Left side bank down under left lower side front with a heater hose (steel pipe) going in at a 90* turn just above housing flange.
If 96 subaru legacy wont start sometimes but will turn over?
Check for spark Check for fuel
What is the problem when the parking lights on your 1989 Subaru GL wagon will not turn off?
chek the switch on top of steering column
96 Subaru legacy Brighton the check engine light comes on it will turn over bt wil not start?
Check this site for information: http://www.troublecodes.net/Subaru/
Where is turn the signal flasher on Subaru Legacy?
1990-1994 take out dashboard and it is on the left take out three screws and the bigger relay is for the blinkers.
