answersLogoWhite

0

How do you turn rotors on a 2000 Nissan Frontier XE?

Updated: 8/17/2019
User Avatar

Wiki User

15y ago

Best Answer

If your rotors need turned (nowadays it's usually better to replace them, and some can not be turned at all), take them to a shop that has the proper equipment. They can look up the specs.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn rotors on a 2000 Nissan Frontier XE?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the turn signal flasher located in a 2002 Nissan frontier?

where is turn signal flasher 2002 nissan frontier


Where is the turn signal relay for a 1998 Frontier Nissan pick up?

The 1998 Nissan Frontier pickup truck turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be above the brake pedal.


Why would the cruise control on a Nissan Frontier turn off when you turn on the headlights?

This sounds like a direct short my 2001 frontier does that too, i was told it was an electrical malfunction.


How do you lower spare tire on 2000 frontier?

You usually turn a nut set in the trunk floor.


What component causes the ac to turn on and off on a 2003 frontier Nissan truck?

The low pressure switch will do that when the system is low on freon.


Need xm radio id for Nissan frontier?

Should be able to turn your radio to channel 0 and it should display your id #.


Why would the front rotors turn after changing the brake pads and rotors?

Possible wrong rotors???


How do you compress the piston on caliper on 2000 Nissan maxima?

turn it in clockwise with a pair of needlenose


What is the problem when you turn the key and don't hear anything on a 2000 Nissan maxima?

A Dead Battery


Nissan quest 2000 won't start?

Does it turn over? Is it getting fuel? Is it getting spark?


2000 Nissan Frontier my tail lights work but my left brake light doesn't how do I fix this?

check the bulb, it has two filaments, one for tail light, another for brake light and indicator. if the turn signal works, it's not the bulb, but a power supply problem.


What is the torque for the center nut when you turn your rotors on my 2000 subaru outback?

Shouldn't have to remove center nut - should be peel off rotors should just have to remove caliper and rotor should slide off center hub