If you disconnect the ABS module, the system will default to conventional brakes, but the ABS light will be on.
What I did was find the correct fuse for for the ABS motor and remove the fuse . the abs light will stay on but this did it for me. or find the motor just in front of the master cylinder and unplug it.
The 2000 Ford Windstar ABS relay switch is located on the firewall in the engine compartment. The relay switch will be on the passenger side of the engine compartment.
On a 2000 Ford Expedition the ABS Relay problem is a problem with the braking system. Either the ABS Relay needs to be replaced or the brake pads are worn down. The ABS Relay is located in the fuse box that is on top of the battery in the engine compartment.
Pull the ABS fuse, unplug a wheel speed sensor, unplug the ABS computer. All of those options will cause the ABS light to illuminate in the cluster.
Bring to a shop that has an ABS scanner to determine problem
A malfunction has been detected - get it checked out
A malfunction with the ABS system has been detected , could be a fuse , a sensor , or some other problem
Why ?
It most likely has an abs problem (a code stored). Go and have the system scanned if you want the reason.
Pull the fuse. In 1996 Windstar, it's fuse #33
How do you clear the abs light on a Ford E-150 van year 2000. Light stayed on after replacing the front brakes.
There should be four sensors, one at each wheel somewhere near the hub.